PI-Remote-HID

Guide to converting your raspberry pi zero w into a remote hid tool (rubberducky/badUSB)

Requirements:

Raspberry Pi Zero W (Could work with other devices, I haven't tested, my steps are for the Raspberry Pi Zero W)

A microSD card with 16GB of storage and a reader.

A micro-USB to USB-A/USB-C cable.

Step 1: Flash the OS

Download https://www.raspberrypi.com/software/ and run it.

Select "Raspberry Pi Zero" in the device option and click on next.

Click on Raspberry Pi OS (other) then Raspberry Pi OS Lite (32-bit) then click on next. (You could use another distro, but I would just recommend raspberry Pi OS Lite, since it's optimized for the hardware.

Then plug in your microSD card and select the device and click on next.

Enter a hostname, I just choose paintress.

Set your capital and timezone and keyboard layout.

Set your username and password. IMPORTANT NOT TO FORGET.

Next set your Wi-fi password right now. It's much easier to do it right now than later, since this is going to be a headless setup guide.

Don't forget to enable SSH so you can remote in.

You can skip on the raspberry pi connect.

Then click on write. and it should format a image for you.